Virtue Sensation Owner’s Manual
http://www.virtueaudio.com
Page 6 of 6
Mono Subwoofer Out:
The mono subwoofer line level output allows you to attach a powered
subwoofer amplifier to the Sensation. Use the provided sub output connection instead of
connecting the Sensation’s high-level speaker outputs to your subwoofer high-level inputs as
this will bridge the Sensation’s speaker outputs and destroy your amp.
WARNING: Do NOT connect the high-level speaker outputs to your subwoofer inputs and use the
subwoofer to crossover the high and low frequencies. With Tripath amps such as this one, there is a
decent chance that your subwoofer amplifier will bridge the amp’s speaker outputs, blowing up your
Virtue amp.
Stereo Pre-outs:
Sensation’s excellent preamp stage can be used as you would a stand-alone preamp,
to drive an external amplifier. Connect the L/R stereo RCA pre-outs, which output a full range signal, to
your other amplifier. We don’t know why in the world one might do this, but it’s possible. If your
Sensation is equipped with the optional Dodd Buffer, you might like to know that the buffer is part of the
preamp signal path.
Connecting Power Supply and Cables
Sensation is shipped with a standard 24v switching power supply or an upgraded 30v switching power
supply. If using another brand power supply, it must not exceed 30v.
Connecting the Power Supply:
Make sure the amplifier power switch in the back is in the “off” position.
1. Connect the power brick to its separate power cable
2. Connect the power supply cable to Sensation (use the 4-pin to bullet adapter if needed,
depending on supply)
3. Plug the power cable into the wall outlet or your power conditioner outlet
If Connecting Batteries:
Make sure the amplifier power switch in the back is “off”. Connect your
batteries as directed by the manufacturer and then connect the power source to the back of the
Sensation. Use the included 4-pin to bullet adapter if necessary. Please see www.virtueaudio.com for
recommended battery options. There is a misprint on the enclosure (it says 39v). The max input
voltage is 30v on Sensation. Do NOT exceed 30v.
Turning On the Amplifier
Sensation has two power switches: a main, manual rocker switch on the back and; a power button on
the front (which can also be controlled by remote).
The way the soft-start is configured, it is best to put the unit into stand-by before shutting it down with
the master power switch or unplugging the power supply. If you mess up, just make sure to wait around
90 seconds before trying to power Sensation back on.
Proper Power On Procedure:
1.
Turn on rear power rocker switch on the back of Sensation
a. At this time you will notice the Protection and Standby LEDs will come on, testing the
power input to make sure it is safe before the amplifier can be turned on
2. Wait briefly for the standby circuit to “click” and charge up
