Iss 8 - Mar 2019
Page 7 of 9
Service and maintenance
DANGER
Contact with live components can result in serious injuries. Isolate the power before commencing any
work.
THERE ARE NO USER SERVICEABLE COMPONENTS WITHIN THIS CHARGE POINT.
Please note
that even though every care has been taken to select only the highest quality components,
in the event that you should experience problems with this unit servicing should only be carried out by a
suitably qualified individual. As the charge point is modular in design the affected component can be
replaced on site with the defective part being sent back to the manufacture for analysis.
Procedure
•
Isolate all power to the charge point.
•
Disconnect the wiring from the affected component by loosening the terminals.
•
Remove the device by pulling the locking slider and swivel the device away from the DIN rail.
•
Install a new device by placing it over the DIN rail and firmly pushing it down until it clicks
into place.
•
Reconnect all wiring and check that
all
connections are tightened to the required torque.
•
Re-establish the power supply to the charge point.
Cleaning
It is recommended that cleaning of the outside of the charge point should be performed using a damp
cloth and a mild cleaning solution.
CAUTION
Cleaning the charge point with a high-pressure water hose is not permitted and could cause water build
up within the charge point.
The charge point should not be opened and cleaned internally.
