Viper AS380/15B-AU, User Manual

Page: 9 / 19

7
Solution tank filling
NOTE
The machine can be filled with a with pipe or bucket. Do not remove the Solution filter (21) while
filling.
1. Fill water into solution tank (3) from the inlet (20) through pipe or bucket
2. Do not fill the solution tank completely, leave a few centimeters from the edge.
3. The water temperature must not exceed 40
℃
.
CAUTION
！
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications
Solution tank draining
NOTE
Solution tank should be drained and cleaned after each scrubber operation is
completed.
1
．
Unscrew the drain cap (22) on the bottom of solution tank. The solution/water will flow
freely into a bucket or floor drain.
2
．
Rinse the solution tank with clean water after every use. This will help prevent chemical
build up and clogging of the solution lines
3
．
Screw up the drain cap (22).
Recovery tank draining
NOTE
Recovery tank should be drained and cleaned after each scrubber operation is
completed.
1
．
Turn the latch (17) off the recovery tank, take off the recovery tank from machine by
grasping two grooves of tank. Open the lid (1) and overturn the recovery tank to
drain the dirty water into a container, or unscrew the drain cap (22) to let water pipe
out to a bucket.
2
．
Clean and Rinse the recovery tank with clean water after every use.
3
．
Re-place the recovery tank on the machine and turn the latch (17) to lock the tank..
MACHINE OPERATION
1
．
Set the handle to a comfortable height by pressing level (25).
2
．
Lower the squeegee (33) onto the floor by pulling down the lift mechanism (26).
USER MANUAL