Viper AS380/15B-AU, User Manual

Page: 10 / 19

8
3
．
Turn on the main switch (47).
4
．
Turn on the brush motor switch (48) and the solution switch (50), the indicate light will be on.
5
．
Turn on the vacuum motor switch (49), the indicate light will be on.
6
．
If necessary, adjust the water flow by turn the ball valve (31) manually
7
．
Pull one or both operating triggers (24), and then brush will start to spin, solution will begin to flow.
Move the machine and start cleaning,
NOTE
If the battery indicator light (51) is green, the machine can be used. If it is yellow or red, the
batteries must be charged.
CAUTION
！
Before lifting the brush, turn it off by pressing the switch (47).
CAUTION
！
When cleaning excessively aggressive floors or others this could cause the machine do not work, brush
motor and vacuum indicators on the Control panel(46) flashing simultaneously. It means the machine
being overloaded.
Please turn off all the switches on the Control panel (46).
CAUTION
！
Do not use the machine with discharged batteries to avoid damaging the batteries and reducing the
battery life.
AFTER USING THE MACHINE
After scrubbing, please proceed with below actions before leaving the machine:
1
．
Remove the brush/pad-holder.
2
．
Empty the tanks as shown in the previous parsagraph.
3
．
Perform the daily maintenance procedures (see the maintenance chapter)
4
．
Store the machine in a clean and dry place, with the brush/pad-holder and the squeegee
5
．
If storing in an area which may reach freezing temperatures, be sure to drain all fluids from the
machine prior to storage. any damage caused by freezing temperatures will not be covered by the
warranty.
MACHINE NOT BEING USED FOR LONG PERIODS
If the machine is not going to be used for more than 30days, please proceed with below actions:
1. Perform the procedures shown in ‘After Using the Machine paragraph’.
2. Disconnect the battery connector.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular
maintenance. The following chart provides the scheduled maintenance. The intervals shown may vary
according to particular working conditions, which will be defined by the person in charge of the
maintenance.
WARNING
Maintenance procedures must be performed with the machine switched off and the batteries/battery
charger cable disconnected. Moreover, carefully read the instruction in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by
USER MANUAL