USER MANUAL
ENGLISH
25
TANK AND VACUUM GRID WITH FLOAT CLEANING, AND COVER GASKET CHECK
1.
Drive the machine on a level floor.
2.
Ensure that the machine is off and the ignition key (54) has been removed.
3.
Turn the recovery tank lid (A, Figure 21) 90 degree position where it can be took off from the tank, and then
take down the float ball filter (P) from the tank.
4.
Clean the recovery tank lid (A), recovery tank (B), clean water tank (C) and the float ball filter support frame
(E). Empty the recovery tank with the drain hose (B, Figure 23).
5.
If necessary, follow the symbols “OPEN” and “CLOSE” as shown in (Figure 21)to open the bottom cover (F)
of float ball filter and then clean the float ball (D), filter support frame (E) and filter sponge (I). After cleaning,
fix the float ball (D) into the filter support frame (E) and then align the mark groove (L) of the bottom cap (F)
of the float ball filter with the mark groove (L) of the float filter support frame (E). Screw the bottom cap of
the float ball filter tight, and fix the filter sponge (I) onto the float filter support frame (E). Finally, connect it
to the sewage suction hose (M).
6.
Inspect the integrity of the tank sealing strip.
NOTE
Tank sealing strip (G) makes to produce the vacuum inside the tank when suction motor works.
The tank must be sealed can effectively absorb the water from the ground to recovery tank.
7.
Check whether the contact surface of sealing strip (G) is integrity and sealing is sufficient. If necessary, take
the sealing strip of the tank out of the groove (H) and replace it. Assembly the new sealing strip as shown in
(Figure 21), the joint should be back in the middle area.
8.
Close the recovery tank lid (A).
Figure 21
P
H
G
J
K
E
D
F
I
L
M
A
C
B
