Manual VIPA HMI
Chapter 2
Deployment Touch Panel
HB160E - TP - RE_62F-FCB0
- Rev. 11/14
2-11
To configure the MPI/DP interface on the Touch Panel start via "Control
Panel" the tool "MPI/DP Slave Configuration".
Default: MPI - Address 1
The following settings are only required if not communicate via Movicon or
zenon.
Via mode the interface could be set up on "DP Slave".
Note!
It is possible to set up the DP slave with the tool via software, but the
hardware of the Touch Panel doesn't support this.
In this case MPI does not work either.
To remain the settings permanently, they have to be saved with
KuK Tools
[Store].
To activate the changes the Touch Panel has to be restarted after
configuration.
Configuration
MPI/DP slave
Configuration
DP slave