Manual VIPA System 200V
Chapter 2 Assembly and installation guidelines
HB97E - PS-CM - Rev. 06/29
2-9
•
Install the connector on the module until it locks with an audible click.
For this purpose you press the two clips together as shown.
The connector is now in a permanent position and can easily be wired.
The following section shows the wiring procedure from above.
•
Insert a screwdriver at an angel into the square opening as shown.
•
Press and hold the screwdriver in the opposite direction to open the
contact spring.
•
Insert the stripped end of the hook-up wire into the round opening. You
can use wires with a diameter of 0.08mm
2
to 2.5mm
2
(1.5mm
2
for
18pole connectors).
•
When you remove the screwdriver, the wire is clipped securely.
Wire the power supply connections first
followed by the signal cables (inputs and outputs).
Wiring procedure
Summary of Contents for System 200V CM
