Chapter 1 Assembly and installation guidelines
Manual VIPA TM
1-4
HB39E - TM - RE_900-2C610 - Rev. 13/28
Assembly
The modules are installed on a profile rail. You may use the following
standard 35mm profile rail:
35 mm
27 mm
15
m
m
1,
5 m
m
35 mm
27 mm
7,
5 m
m
1 m
m
The following sequence represents the assembly procedure as viewed
from the side.
•
Install the profile rail. Make sure that a clearance of at least 100mm
exists above and 70mm below the middle of the profile rail.
100 m
m
70
m
m
Clack
•
Insert the module that you are installing into the profile rail at an angle
of about 45 degrees from the top and rotate the module into place until
it clicks into the profile rail with an audible click.
General
Assembly
procedure
Summary of Contents for 900-2C610
Page 1: ...VIPA Accessories Teleservice module 900 2C610 Manual HB39E_TM RE_900 2C610 Rev 13 28 July 2013...
Page 4: ...Contents Manual VIPA TM ii HB39E TM RE_900 2C610 Rev 13 28...
Page 8: ...Safety information Manual VIPA TM 4 HB39E TM RE_900 2C610 Rev 13 28...
Page 70: ...Chapter 3 Deployment Manual VIPA TM 3 44 HB39E TM RE_900 2C610 Rev 13 28...
