For the cabling of power supply of a CPU, a green plug with Cage-
Clamp technology is deployed. The connection clamp is realized as
plug that may be clipped off carefully if it is still cabled.
Here wires with a cross-section of 0.08mm
2
to 2.5mm
2
may be con-
nected. You can use flexible wires without end case as well as stiff
wires.
1 Test point for 2mm test tip
2 Locking (orange) for screwdriver
3 Round opening for wires
The picture on the left side shows the cabling step by step from top
view.
1.
For cabling you push the locking vertical to the inside with a
suiting screwdriver and hold the screwdriver in this position.
2.
Insert the de-isolated wire into the round opening. You may use
wires with a cross-section from 0.08mm
2
to 2.5mm
2
3.
By removing the screwdriver the wire is connected safely with
the plug connector via a spring.
In the following the cabling of the two variants are shown.
CageClamp technology
(green)
Front connectors of the
in-/output modules
VIPA System 300S CPU
Assembly and installation guidelines
Cabling
HB140 | CPU | 315-2AG13 | GB | Rev. 14-40
20
