1.
Install your System 300S with your CPU.
2.
Wire the system by connecting cables for voltage supply and
signals.
3.
Connect the Ethernet jack of the Ethernet PG/OP channel to
Ethernet.
4.
Switch on the power supply.
ð
After a short boot time the CP is ready for communication.
He possibly has no IP address data and requires an initiali-
zation.
The initialization via the Online functions takes place with the fol-
lowing proceeding:
Determine the current Ethernet (MAC) address of your Ethernet
PG/OP channel. This can be found as 1. address under the front
flap of the CPU on a sticker on the left side.
You get valid IP address parameters from your system administrator.
The assignment of the IP address data happens online in the Sie-
mens TIA Portal with the following proceeding:
1.
Start the Siemens TIA Portal.
2.
Switch to the
‘Project view’
.
3.
Click in the
‘Project tree’
at
‘Online access’
and choose here by
a doubleclick your network card, which is connected to the
Ethernet PG/OP channel.
4.
To get the stations and their MAC address, use the
‘Accessible
device’
. The MAC address can be found at the 1. label beneath
the front flap of the CPU.
5.
Choose from the list the module with the known MAC address
(Onboard PG/OP [MAC address]) and open with "Online & Diag-
nostics" the diagnostics dialog in the Project area.
6.
Navigate to
Functions > Assign IP address
. Type in the IP con-
figuration like IP address, subnet mask and gateway.
7.
Confirm with [Assign IP configuration].
ð
Directly after the assignment the Ethernet PG/OP channel is
online reachable using the set IP address data. The value
remains as long as it is reassigned, it is overwritten by a
hardware configuration or an factory reset is executed.
Assembly and commis-
sioning
"Initialization" via
Online functions
Assign IP address
parameters
VIPA System 300S CPU
Configuration with TIA Portal
TIA Portal - Hardware configuration - Ethernet PG/OP channel
HB140 | CPU | 315-2AG13 | GB | Rev. 14-40
141
