9
Section 5: Wall Mounting
1. Open the package, take out the product with foam still attached, and gently place it on a
desktop or table. If the monitor was attached to the stand, remove the stand.
Monitor
Stand Base
Foam
Foam
Stand Stem
2. Remove the original screws x 4 (
1
) from the opening in the back of the monitor, and then
use the NO. 3 Screws provided to secure the rear panel.
- Do not discard the original screws. They are needed to secure the rear panel for
the stand installation. Refer to Section 4.
- Use only the NO. 3 Screws (31 mm x 2 pcs, 26mm x 2 pcs) provided. You
MUST
follow the figure below to finish the installation.
Use the 31mm
NO. 3 Screws x 2
Use the 26mm
NO. 3 Screws x 2
3. Follow the directions received with your mounting base (not included) and install the
monitor on the wall.
Mounting Base
(Not included)
1
Summary of Contents for GN32LD
Page 1: ...OR CURVED GAMING MONIT USER MANUAL GN32LD ...
Page 2: ......
