SENSOR INDICATORS
INSTALLATION - DROP CEILING WITH EXISTING OUTLET*
(WHOLE ROOM UNIT/BATH UNIT WITH 2’ X 2’ ADAPTER)
1.
Remove the existing ceiling tile.
2. Plug the S.A.G.E. power cord into outlet.
3. Position the S.A.G.E. unit onto ceiling grid.
4.
Insert cut-to-size ceiling tile to sit flush against the
S.A.G.E. unit. See instructions below for cutting
tile to size.
*If there is no existing outlet, install a 110V, 15
Amp outlet. This may be subject to applicable
permitting. Please consult with a licensed
electrician.
Whole Room Units
1. Measure and mark a 5 3/4” section on the ceiling tile.
2.
Use a box cutter or other appropriate tool to cut off the 5 3/4” section of the tile.
Micro Units with Adapter Plates
If installing the Micro unit with 2’ x 2’ adapter, no cuts are required.
For hard-ceiling installation, contact Violet Defense for additional guidance.
To install in a 24” x 48” grid, cut the ceiling tile to fit using a box cutter or appropriate
tool.
CUTTING CEILING TILE TO SIZE
Each S.A.G.E. UV unit comes standard with mounting holes for standard VESA bracket.
This enables a variety of installation methods, including wire suspension and wall
mounts. The VESA holes also allow for integration with a variety of mobile stands, such
as tripods or bases with caster-wheels.
The Micro units can also be used with base stand to position in various rooms on
tabletops, desks, counter tops, etc.
(Brackets and stands sold separately)
OTHER DEPLOYMENT OPTIONS
INS
TALLA
TION
© Copyright 2020 Violet Defense, LLC All Rights Reserved SUV-GEN2-UM2020
11
