GETTING STARTED AND INITIATING A DISINFECTION CYCLE
1.
After completing the setup instructions, the Vioguard Cubby / Cubby+ is ready for use.
2.
Open the front door.
3.
Pull out the tray.
4.
Place your item on the tray.
a.
For the Cubby, if you desire to use the pass-through USB port, plug your USB cable into the
connector port located to the rear left of the tray. Connect the unit via a USB A-B cable to a
computer or power supply depending on the device needs.
b.
Please note that the Cubby+ does not have USB pass-through and the rear USB port is non-
functional.
5.
Push the tray back into the unit.
6.
Close the door to begin the disinfection process.
7.
The LCD will indicate the start of the cleaning process.
8.
Please refer to the LCD Panel Indications for more information regarding the Disinfection Cycles.
9.
Please note that there is a 1-second delay in startup to prevent surges to the power supply if the
door is opened and closed rapidly. The door needs to be open for at least 1 second for the unit to
begin the disinfection cycle.
2.
3.
4.
6.
