Notice
Caution:
Any changes or modifications to this device not explicitly approved by the manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Shenzhen Viofo Technology Co.,Ltd, declares that this Radio Frequency peripheral is in
compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
Customer Service
12-month Limited warranty , Lifetime technical support
www.facebook.com/viofo.world
+86 755 8526 8909 (CN)
Mon-Fri 9am-6pm
Firmware Upgrade
Follow the instructions on this website to upgrade the firmware:
(https://support.viofo.com/support/solutions/19000101567)
Note:
• Before using a microSD card to upgrade the firmware, formatting the card in the
camera is necessary to ensure stable read and write operation.
• Do not unplug or power off the camera during a firmware upgrade, it may cause
the camera to subsequently fail to boot.
18
17
