102
Replacing tripod legs (ENG tripods)
Introduction
1
The legs are secured in the bowl assembly by pivot clamps. Each clamp is secured by a single screw.
Consumables
2
The following adhesive will be required:
Loctite 221 (Vinten Part No. Z002-026)
Removal
3
Remove the tripod leg as follows:
3.1
, which passes through one of the leg pivot clamps
and
screws into the bowl assembly
.
3.2
Remove the screws
and leg pivot washers
securing the leg pivot clamps
to the bowl
assembly
3.3
Pull off the tripod leg
. Note orientation and remove two leg pivot friction rings
and two leg
pivot washers
Installation
4
Install the tripod leg as follows:
4.1
Install two leg pivot friction rings
and two leg pivot washers
on the tripod leg
, oriented
as noted in removal
4.2
Position the leg in the bowl assembly
, ensuring that the leg pivot friction rings
are correctly
seated.
4.3
Install the leg pivot clamps
and secure with screws
and leg pivot washers
, using Loctite
221. Tighten screws to a torque of 4.5 Nm (40 lbf in.).
4.4
If required, install the hook
, using Loctite 221.
NOTE:
Do not apply any lubricant to the bowl, the leg trunnions, leg pivot friction rings or
washers.
Summary of Contents for Vision Pozi-Loc
Page 1: ...Contents Vinten Camera Control Solutions Next Page Previous View Vision Pozi Loc Tripods ...
Page 8: ...8 Contents Previous Page First Page Next Page Previous View Part 1 Illustrated Parts Lists ...
Page 85: ...85 Contents Previous Page First Page Next Page Previous View Part 2 Repairs ...