23
Adjustments
10
After considerable use the platform slide clamp or pan and tilt brakes may require adjustment.
Platform slide clamp adjustment
11
The platform slide clamp should be set so that, in the up or clamped position it prevents the platform
slide from being moved, while in the down or released position it allows free adjustment of the slide. To adjust
the clamp, proceed as follows
:
11.1
On the right-hand side of the platform, carefully remove the self-adhesive label
to reveal the
slotted shaft
11.2
Pull the slide clamp lever
fully upwards.
11.3
Slacken the clamp screw
11.4
Using a torque screwdriver, turn the slotted shaft
fully clockwise to a torque of 4.0 Nm
(35 lbf in.).
11.5
Tighten the clamp screw
.
11.6
Move the lever over its full range and ensure that, in the clamped position, it prevents the slide
from being moved, while in the released position it allows free adjustment of the slide. Re-adjust if
necessary.
11.7
Replace the self-adhesive label
in the recess in the platform.
Fig 4.3 Platform Slide Clamp Adjustment
(3)
(4)
(2)
(1)
V70_CLAM