15
Section 2
Operation
Contents
Para
General
1
To identify components, please refer to
and
.
Assembly
2
If not already done, assemble the system as follows:
Tripod and spreader
3
Lift the tripod out of the case using the finger holes just below the top clamps.
4
Release the leg tie strap
and spread the legs.
5
Secure the spreader to the tripod feet with the rubber straps
6
Adjust the operating height by undoing the leg clamps
and pulling the tripod up to the desired
if necessary.
7
until an audible click is heard and the knob is in the horizontal, locked position.
8
In adverse conditions secure the tripod using the tie-down hook
, or suspend a weight from the
hook.
NOTE:
Once assembled, keep the spreader attached to the tripod
WARNING!: Use care when the tripod is fully extended and the floor spreader is in the
closed position, as stability will be reduced.