26
Adjustments
Elevation unit on-shot clamp
After considerable use the on-shot clamp may require adjustment. If the rotation between the ‘off'
stop and the fully ‘on' position exceeds 120°, adjust the clamp as follows:
Remove the hole plug
(16.5)
. Remove the screw
(16.4)
and washer
(16.3)
securing knob
(16)
to lock spindle
(16.2)
. Remove the knob.
Turn spindle clockwise to fully tighten clamp, then turn counter-clockwise 120° (two flats).
Position knob on spindle so that it is against the stop screw
(16.1)
. Ensure that rotation to
fully ‘on' is less than 120° and that the clamp is fully ‘off' when against the stop screw. Re-
move knob and rotate spindle until this is achieved.
Secure knob with screw
(16.4)
and washer
(16.3)
, using Loctite 222E. Refit hole plug
(16.5)
.
Studio Dolly Tracking
(19)
(19.3)
(19.2)
(19.1)
Summary of Contents for HDT Heavy-Duty
Page 1: ...Vinten Camera Control Solutions Operators Guide HDT Heavy Duty Tripod Range ...
Page 7: ...7 HDT 1 Tripod 1 2 3 4 6 5 7 8 9 10 11 6 5 1 5 2 5 3 5 4 12 ...
Page 9: ...9 14 Four bolt head fixing 15 Elevation handle 16 On shot clamp Elevation unit 14 15 16 ...
Page 17: ...17 Installing or Removing the Elevation Unit 8 12 13 1 8 1 12 2 12 3 13 2 13 13 3 12 1 ...
