22
9.5
Position the battery in the battery compartment, ensuring that the wiring is neatly stowed in the
cut-out provided.
9.6
Refit the battery cover
.
9.7
Press the switch
and ensure that the level bubble
is lit for approximately 15 seconds.
Adjustments
Brake knob
adjustment
10
:
10.1 Turn the knob counter-clockwise to its lower stop.
10.2 Unscrew the securing screw
until its stop is reached
10.3 Turn the knob until it is 15° below the horizontal, then pull the knob off the shaft.
11
:
11.1 Turn the shaft clockwise, by hand, until the brake is applied.
11.2 Turn the shaft 60° counter-clockwise.
11.3 Push the knob onto the shaft at the 15° position.
11.4 Turn the knob clockwise to the horizontal position and push it inwards..
11.5 Screw in the securing screw
. Do not overtighten.
12
Turn the knob clockwise and ensure that the brake is fully applied before the upper stop is reached.
13
Turn the knob counter-clockwise and ensure the brake is released before the lower stop is reached.
14
Re-adjust the position of the knob if necessary.
NOTE:
The pan and tilt brake knobs are set during manufacture so that the brakes are fully
applied before the knobs reach their upper stops. As the brakes bed in during use it may
be necessary to reset the knobs.
The procedure shown is for the tilt brake knob.The pan brake is adjusted in a similar
fashion