16
Mk 5 Pan & Tilt Head Maintenance Manual
Camera fitting
2
Move head locking stays from the folded position to the locking screws and tighten thumb nuts (Fig 2.1).
3
Ensure that the socket headed screws holding the wedge adaptor plate to the head plate are tight.
4
Remove pip pin from wedge locking bar and extend bar handle to its full travel.
5
With the camera wedge fitted to the base of the camera, fit to the head by inserting wedge into adaptor
and close locking bar lever to the head.
NOTE:
1. Insert pip pin to its full limit of travel (Fig 2.2).
2. Before proceeding further ensure that camera is complete with all its ancillary
equipment i.e. lens, co-axial cable etc. and that pan bar(s) is (are) fitted to the head.
Fig 2.2 Pip pin
Correct position
of pip pin