Vinteck
V-8 – true-bypass MIDI switching pedalboard
pag.5
Edition 01eng rev. 0
5-
installation and connections
(
wiring)
All connection are on back side of V-8
Low, from left to right:
- BFR ON/OFF switch on or off the buffer on guitar buffer. Buffer must be switched off on case of signal higher
than +4 dB . IN case of use of pre buffered signal, just test best solution for you ear.
- IN
Guitar, or bass, input
- TUNER
Direct output from guitar IN. May be used for tuner. Note: there is not any MUTE function.-
- IN TRUE
True bypass input. Any signal may be inserted..
- LOOP1-5
loops managed from buttons 1 to 5
SND
Signal for pedal input
RTN
Signal back from pedal.
- EXT LOOP Fixed loop. Usable for always ON pedals (ex volume) or for amp effect loop connection. (see
Example)
- LOOP6
loops managed from buttons 6
- EXT LOOP Fixed loop. Usable for always ON pedals (ex volume) or for amp effect loop connection. (see
Example)
- LOOP7-8
loops managed from buttons 7 and 8
- OUT
OUTPUT signal
- EXSW
input for external switch, temporary switch must be used.
- S 1-2-3-4
NO contact (normally open). Close HOT on GROUND. For amps channel switching.
- MIDI IN/OUT IN and OUT MIDI socket
- DC IN
Power supply input. Not less than 12 VDC, 500mA (450mA required when all loops/switch are
active)
PEDALBOARD
