Vino Pins Flex System
Installation guide for the Vino Series Flex (VP-Flex) products
Included:
• (1) Vino Pins Flex Neck Mounting
Strip
• (1) Vino Pins Flex Base Mounting
Strip
• (6) Mounting Hole Caps
• (2) Plastic Couplers
• (4) Spiral Drywall Anchors
• (6) Screws
Important Note:
These installation instructions will assist you with installing the VintageView Vino Pins Flex System into wood-
backed or drywall surfaces.
Surfaces:
Drywall and wood surfaces must be a minimum of 1/2” (12.7mm) thick.
Additional Components:
(may be
sold separately)
• Vino Pins
• Vino Pins Extensions (optional)
Required Tools:
• Phillips head screwdriver
• Level
• Pencil
• Tape measure
• Drill
• 1/2” Drill bit (spade)
• 1/16” Drill bit
• Protractor or adjustable level for
angled installs
1. ORIENT THE MOUNTING STRIPS
Identify the front and top of each mounting strip, then
note which of the two is for Vino Pins Neck pieces.
The front of the Mounting Strip has more 1/4”
(6.5mm) holes than 1/2” (13mm) holes.
To identify the top of each Mounting Strip, note the
side with the 1/2” (13mm) mounting holes closer to
the top.
Finally, the neck side of the mounting strip has the
higher (offset) of the 1/4” (6.5mm) holes.
Front
Top
Neck
