Instructions
Figure E
8. Hang the Backer Strip
If drywall
, remove the expanding nut from toggle
bolt and insert through the top mounting hole on your
Backer Strip.
With the wings of the nut oriented to fold toward the
bolt head, thread the expanding nut onto the bolt so
the tip of it starts to protrude form the end of the nut.
Hold the strip so the toggle bolt aligns with the top
mounting and gently push the nut through the wall (Fig-
ure D). Ensure the wings have fully expanded on the
backside of the wall and gently tighten, verifying the
necks remain level. Secure the rest of the strip through
the bottom two mounting holes with provided screws.
Fully tighten the toggle bolt.
If wood,
use provided screws and install the Backer
Strip to the wall at the marked mounting hole locations.
9. Hang the Next Backer Strip
Repeat steps 5-8 with the second Backer Strip, center-
ing it horizontally with the second mark on your wall
from Step 4 and ensuring the tops of the strips even
with each other.
10. Install Mounting Hole Caps
Press supplied mounting hole caps into the open holes
of the face of each Backer Strip.
11. Add wine
Only the good stuff.
Maintenance and Care:
Vino Series wine racks are backed by a lifetime warranty. They should be regularly checked for tightness. Should any piece
to be found to be loose, tighten by hand until secure. If the face of the wall surface shows signs of breakage, discontinue use
immediately until the wall may be adequately repaired. Vino Series products may be cleaned with a damp cloth and mild
dish soap — abrasive pads or steel wool should NOT be used as they will damage the finished surfaces of the parts.
Need more help? Visit VintageView.com