Instructions
Figure D
Figure C
4. Lay out Wall
Starting at least 2 3/4” (70mm) from adjacent wall
or other obstructions, mark the centerline of the first
Backer Strip. From there, measure 7 1/2” (190.5mm) for
Pins and 2 1/2” for Rails (63.5mm) to centerline of the
second Backer Strip.
5. Mark Mounting Hole
Locations:
Hold one Backer Strip (careful to note if it’s the Base or
Neck for Vino Pins options) in place against the wall,
centered on the first mark at your preferred distance
from floor. Ensure the Strip is plum using a level and
mark hole locations with a pencil (Figure B). Backer
Strips can be installed on angles up to 45 degrees
(figure C).
Set strip aside.
PRO TIP: When installing Flex at an angle, the tops of
the Backer Strips will not remain flush. For Vino Pins,
ensure the Pins on the Neck side are offset 5/8” above
the Base side. For Vino Rails, ensure the Rails remain
level.
6. Check for Wood Studs
Drill 1/16” (1.5mm) pilot holes at marked locations to
check for studs or wood backing.
7. Drill Mounting Holes
If Drywall:
For the lower two holes us a Phillip’s
head screw driver to insert spiral drywall anchors into
wall until it is flush with the surface. For the top mount-
ing point, drill a 13/23” (10.3mm) hole for toggle
bolt.
If wood or stud:
Skip to next step.