Instructions: Low Profile Post System
Double check the Post is plumb with a level and secure
the Post to the floor using two (2) of the appropriate fas-
teners (not provided).
14. ATTACH THE FIRST WINE RACK ROWS
Fasten the bottom Wine Rack Row Assembly to the sec-
ond Post using two (2) Self-Drilling Screws.
** Use a low-torque setting on the Power Drill. **
Repeat with the top and middle Wine Rack Row Assem-
blies using two (2) Self-Drilling Screws each.
Use a level and square to ensure each Wine Rack Row
Assembly is level before fully tightening.
15. BUILD/INSTALL REMAINING
WINE RACK ROW ASSEMBLIES
Repeat step 9 to build all remaining Wine Rack Rows for
the column. Starting from the lowest remaining mounting
hole locations, secure each remaining Wine Rack Row
using four (4) Self-Drilling Screws into your pre-drilled
holes. Work up until column is complete.
For single-column installations, skip to step 19 to finish
the procedure. Continue to next step if adding additional
Low Profile Post System Columns.
MULTI-COLUMN INSTALLS
(Figure J)
16: BUILD AND ATTACH FIRST ROWS
Using Step 9, build the first three (3) Wine Rack Rows
for the next column. Attach the bottom, top, and middle
Wine Rack Row Assemblies to the second Post using two
(2) Self-Drilling Screws each.
17. BUILD THE NEXT POST
Repeat steps 2-6 to build the next Post. If installing addi-
tional connected Low Profile Columns, be sure to pre-drill
Mounting Plate Holes on two opposite sides of the Post.
18: COMPLETE THE NEXT COLUMN
Repeat steps 13-15 to complete the column. Steps 16-18
can be repeated as many times as necessary to scale the
size of the Low Profile Post System to meet your specifica-
tions.
19: ADD WINE
Hopefully the good stuff.
Problems?
Try BILT 3D intelligent instructions, visit
Figure I
Figure J
www.vintageview.
com, or call 303-504-
9463.
Care:
The Low Profile Post
should be regularly
checked for tightness.
Should any part be
found to be loose,
tighten until secure.
Components may be
cleaned a dry dusting cloth, compressed air cans,
or rubbing alcohol and a clean cloth. Do not use
cleaning supplies or abrasive surfaces as they will
damage the finished surfaces of the parts.
