Instructions
Figure D
Figure C
4. Lay out Wall
Skip to Step 5b if installing Flex at an angle.
Starting at least 23/4” (70mm) from adjacent wall or
other obstructions and 1” from the ceiling, mark the
centerline of the first Mounting Strip. From there, mea-
sure the distance, noted in chart below by bottle type,
to centerline of the second Mounting Strip.
5a. Mark Mounting Holes
Hold one Mounting Strip (careful to note the top of the
Strip and, for Vino Pins, if it’s the Base or Neck side)
in place against the wall, centered on the first mark
at your preferred distance from floor. Ensure the Strip
is plum using a level and mark hole locations with a
pencil (Figure B). Mounting Strips can be installed on
angles up to 45 degrees (figure C). Set strip aside.
Proceed to Step 6.
5b. Mounting Hole at an Angle
Flex mounting strips can be mounted between at
angles between 45° and 135° when storing bottles
with a 3” diameter. Using a speed square or protrac-
tor, hold the first Mounting Strip in desired location set
to preferred angle. Mark mounting holes. For second
Mounting Strip locations use a level to measure across,
from the center of the mounting locations of the first
Strip, the distance noted below. For Vino Pins Flex*,
the Neck side mounting holes should be offset 3/8”
below the Base side. For Vino Rails Flex* the mounting
holes will remain level.
Pro tip: Test the fit of irregularly shaped bottles by
checking your layout angles on the floor first.
*NOTE: For Vino Pins Flex installs at an angle, the
tops of each Strip will not be flush.
Mounting Hole Centerline Measurements:
• Vino Pins Standard (750ml): 7.5” (190.5mm)
• Vino Pins Magnum (1.5L): 8.5” (216mm)
• Vino Pins Standard (750ml): 2.5” (63.5mm)
• Vino Pins Magnum (1.5L): 3” (76.5mm)