Instructions: W Series Frame Standoff Bracket
Note:
For detailed instructions installing the included
or any additional Base Plate, refer to specific product’s
instructions.
3. Cut the Frame:
Using a reciprocating saw, band
saw, or hack saw with the appropriate blade; squarely
cut both legs of the frame at the marks from Step 2 (Fig-
ure D). With a metal file, carefully remove any resulting
burrs from the cuts.
Pro-Tip:
An abrasive cut-off saw should not be used, as
the heat generated is likely to damage the finish of the
W Series Frame.
5. Insert the mounting plates
Slide the C-channels of the Standoff Brackets into the
the open end of frame, ensuring that it is seated flush
against the horizontal plate. Then, install the wall
brackets and secure both sets with a self-drilling screw
through the side of the frame.
4. Attach the Racks:
Secure the W Series racks
and/or W Series Frame Backer Bar to the front and
back faces (Figure D), ensuring that the coupled joint
of the frame is spanned by the back strip of a W Se-
ries rack or a backer bar and that the rack or backer
bar spanning the joint is screwed into both the upper
and lower sections of the frame.
6. Install the frame
Position the assembled frame, ensuring it is plumb
both front to back and side to side using a level, and
fasten at the top through all available mounting holes
(Figure F). Mounting hardware from your W Series
wine rack works great for this. Then, secure the bot-
tom of the frame through the holes in the mounting
plates.
Figure C
Figure D
Figure F
Figure E
