GLT-299-7-9 Rev. 0
Mar 23, 2018
1
Instruction Manual
VDOT-STB-RL
Relay Base
Before Installation
Please read these instructions carefully and keep for future reference.
The information in this document is subject to change without notice. For updates please refer to our website.
Note:
Follow the requirements for the installation of the products in accordance with the Specifications. Otherwise
it may cause damage to equipment.
Note:
Do not install the product in any location where oil, dust, iron powder, chemicals, or hydrogen sulphide may
occur or affect the product. It may cause damage to equipment.
Section 1 – INTRODUCTION
VDOT-STB-RL is a detector base with relay output for use with Zeta Control Panel series, which is designed for
use with an addressable detector. When a detector is in alarm condition, the base receives a control signal from
the detector, which has the relay operate. The rating of contact is DC30V/1A.
Section 2 – TERMINALS
VDOT-STB-RL base is supplied with 2 terminals as standard, along with a relay output terminal block of C form
contact.
The terminals of VDOT-STB-RL base are configured as follows:
-
Terminal 1 = SLC positive
-
Terminal 6 = SLC negative
-
Terminal 3 = No connection
-
Relay terminal block with N/O, N/C, and COM
! CAUTION
Do not use the products outside the rated power supply voltage range specified in
the Specifications. It may cause a fire or damage to equipment.
Do not disassemble, repair, or modify the products. It may cause a fire or electric
shock.
! CAUTION
! CAUTION
Make sure to turn the power off before commencing any wiring work. Otherwise
it may cause electric shock or damage to equipment.
ZETA ALARMS LIMITED
72-78 MORFA ROAD, SWANSEA, SA1 2EN
http://www.velocitydetection.com
