Vintage Air 571064, Manual

Page: 12 / 24

12
www.vintageair.com
901304 REV D 02/28/2017, PG 12 OF 23
Remove OEM caster/camber access panel from passenger side wheel well (discard) (See Figure 10, below).
Install (4) grommets in inner fender cap (See Figure 10a, below).
Install inner fender cap in wheel well side using (2) #10 x 1/2” sheet metal screws as shown in Figure 10a,
below.
Install hardlines in inner fender cap as shown in Figure 10b, below.
Install Adel clamps onto hardlines as shown in Figure 10b, below.
Using Adel clamps as a guide, drill (5) 3/16” holes in inner fender. Secure Adel clamps and hardlines to
inner fender using (5) 10-32 x 3/4” pan head screws and (5) 10-32 nuts with star washers as shown in
Figure 10b, below.
Inner Fender Cover
& Hardline Installation
1.
2.
3.
4.
5.
6.
OEM Caster/Camber
Access Panel
(2) #10 x 1/2”
Sheet Metal Screws
(Included in Hose Kit)
Inner Fender Cap
496118
(Included in Hose Kit)
Grommet
331460
(Included in Hose Kit)
Grommet
33135-VUI
(Included in Hose Kit)
(2) Grommets
33136-VUI
(Included in Hose Kit)
Figure 10b
Figure 10a Figure 10
(2) #2 Adel
Clamps
(Included in Hose Kit)
(5) 10-32 x 3/4”
Pan Head Screws
& 10-32 Nuts
w/ Star Washers
(Included in Hose Kit)
#6 Inner Fender Hardline
101003
(Included in Hose Kit)
Inner Fender Heater Hardline
(Heater Control Valve/Intake)
101012
(Included in Hose Kit)
Inner Fender Heater Hardline
(Evaporator/Water Pump)
101005
(Included in Hose Kit)
#10 Inner Fender Hardline
101004
(Included in Hose Kit)
Drill (5)
3/16” Holes
(4) #4 Adel
Clamps
(Included in Hose Kit)