7
www.vintageair.com
905647 REV B 07/17/19, PG 7 OF 33
Dash Modification
1.
2.
Mark the dash area as shown in Photo 1, below.
NOTE: Offset the marked area 1/8” to the right of the
dash padding/dash metal seam (See Photo 1, below). This will allow for the center louver bezel
to seat flat against the dash padding. Do not exceed the dimensions shown in Photo 1, otherwise,
the opening will encroach on the area for the installation of the mounting screws.
Cut and remove the dash (See Photo 2, below).
Photo 1
Photo 2
7 ¾”
2 ½”
1/8” Offset
Cut and Remove
Cut Out This Area
Dash Padding/
Dash Metal Seam
Measure from
Bottom of
Dash Pad
Summary of Contents for 561191
Page 33: ......
