19
901196 REV B 07/08/14, INST 1970-78 CAMARO wo AC EVAP KIT PG 19 OF 29
1.
Install duct hoses as shown in Figure 21, Page 18.
2.
Install 3/8” ID grommet (See Figure 19, below).
3.
Route A/C wires through 3/8 ID grommet as shown on Figure 19, below (12 volt/ground/binary switch/
heater valve).
4.
Install control panel assembly.
5.
Plug the wiring harness into the ECU module on the sub case as shown in Figure 21, Page 20 (Wire according
to wiring diagram on Pages 21 & 22).
6.
Install glove box (See Figure 20, below).
7.
Reinstall all previously removed items (battery tray & battery).
8.
Fill radiator with at least a 50/50 mixture of approved antifreeze and distilled water. It is the owner’s
responsibility to keep the freeze protection at the proper level for the climate in which the vehicle is operated.
Failure to follow antifreeze recommendations will cause heater core to corrode prematurely and possibly burst
in A/C mode and/or freezing weather, voiding your warranty.
9.
Double check all fittings, brackets and belts for tightness.
10.
Vintage Air recommends that all A/C systems be serviced by a certified automotive air conditioning technician.
11.
Evacuate the system for a minimum of 45 minutes prior to charging, and leak check prior to servicing.
12.
Charge the system to the capacities stated on the information page (Page 4) of this instruction manual.
13.
See Operation of Controls procedures on Page 23.
1.
Install glove box provided, and secure with OEM screws through OEM holes (See Figure 20, below).
2.
Install glove box door.
3/8” ID
Grommet
33144-VUI
Firewall
Cover
Final Steps
Glove Box Installation
Glove Box
Figure 20a
NOTE: If equipped with the glove box light as
shown below in Figure 20a, modify plastic
glove box using template provided on Page 25.
Figure 20
Figure 19
