7
904144 REV A 1/9/12, INST 1970-72 CUTLASS w/ AC EVAP KIT PG 7 OF 25
REMOVE GLOVE BOX DOOR (RETAIN) AND GLOVE BOX (DISCARD) (SEE FIGURE 2 BELOW.)
DISCONNECT ALL WIRE AND CABLES FROM CONTROL PANEL AND RADIO.
REMOVE RADIO AND CONTROL PANEL (RETAIN)
ALL HOSE AND DUCTING FROM O.E.M LOUVERS, SEE FIGURE 2 BELOW
OEM UNDER DASH LOUVER ASM AND (2) OEM LOUVERS IN DASH (RETAIN). (SEE FIGURE 2)
OEM DEFROST DUCT ASSEMBLY BY STRAIGHTENING 4 METAL TABS, SEE FIGURE 2 BELOW.
OEM AC/ HEATER ASM. (DISCARD) SEE FIGURE 2 BELOW.
PASSENGER SIDE KICK PANEL/ FRESH AIR DOOR ASM AS SHOWN IN FIGURE 2a
PASSENGER COMPARTMENT
CONDENSER ASSEMBLY & INSTALLATION
REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH THE CONDENSER KIT TO INSTALL THE
CONDENSER.
BINARY SWITCH INSTALLATION (REFER TO CONDENSER INSTRUCTIONS)
REFER TO SEPARATE INSTRUCTIONS INCLUDED WITH THE BRACKET KIT TO INSTALL THE
COMPRESSOR BRACKET.
IN MOST INSTANCES THE BELT LENGTHS WILL REMAIN THE SAME.
COMPRESSOR & BRACKETS
PULLEYS
REMOVE THE FOLLOWING:
DEFROST DUCT
ASM
OEM A/C
HEATER ASM
AC/HEATER
ASSEMBLY &
RELATED
DUCTING
UNDER DASH
LOUVER ASM
FIGURE 2
FIGURE 2 a
FRESH AIR
DOOR ASM
PASSENGER
SIDE
KICK PANEL
CONTROL
PANEL
RADIO
GLOVE BOX
& GLOVE BOX
DOOR
METAL
TABS
METAL
TABS
Summary of Contents for 1970-72 Cutlass
Page 25: ......
