6
www.vintageair.com
905168 REV G 4/13/15, PG 6 OF 17
Locate the (3) cable converter assemblies. Using a pair of wire cutters, cut the cable converter actuator rods as
shown in Figure 4, below.
Cable Converter Assembly
Modification
1.
Install cable converter assembly mounting clamps.
NOTE: Orient clamps in relation to the (3) housing
snaps on the cable converter assembly (See Figure 5, below).
Cable Converter Assembly
Mounting Clamp Installation
1.
Cut at Each Side
of Hole as Shown
Off/Hi Lever
Cut at 2nd Hole
(Remove Shaded Portion)
Cold/Hot Lever
Cut at 6th Hole
(Remove Shaded Portion)
Dash/Floor/Defrost Lever
Cut at 3rd Hole
(Remove Shaded Portion)
Cable Converter
Actuator Rod
Cable Converter
Assembly Mounting
Clamp
Cable Converter
Assembly
Off/Hi
Cable Converter Assembly
Orient Cable Converter Assemblies and Install Mounting Clamps as Shown.
Cold/Hot
Cable Converter Assembly
Dash/Floor/Defrost
Cable Converter Assembly
Figure 4
Figure 5
Summary of Contents for 1967-68 CAMARO w/o Factory Air Gen IV
Page 17: ......
