8
901302 REV E 07/16/19, SLIMLINE COOL PG 8 OF 11
#6 O-RING
#8 O-RING
#10 O-RING
FOR A PROPER SEAL
OF FITTINGS
INSTALL SUPPLIED
O-RINGS AS SHOWN
AND LUBRICATE
WITH SUPPLIED OIL.
FIGURE 3A
FIGURE 3
MAKE ELECTRICAL CONNECTIONS, ACCORDING TO THE DIAGRAM FURNISHED ON PG. 9.
NOTE: THE RED 12GA. WIRE WITH THE 30 AMP CIRCUIT BREAKER SHOULD BE CONNECTED TO A 12
VOLT POWER SOURCE OF AT LEAST 12GA. WIRE. CONNECT MOLDED PLUG WITH THE (RED, YELLOW,
ORANGE) WIRES TO THE CORRESPONDING PLUG FROM THE BLOWER MOTOR. THE SINGLE BLACK WIRE
FROM THE BLOWER MOTOR MUST BE GROUNDED. THE BLUE CLUTCH WIRE RUNS FROM THE THERMOSTAT
TO THE COMPRESSOR SAFETY SWITCH AND FROM THE SAFETY SWITCH TO THE COMPRESSOR.
BE CAREFUL
TO ENSURE THAT THIS WIRE IS NOT PINCHED OR IN A POSITION TO RUB ON A SHARP
EDGE AS IT GOES THRU THE FIREWALL.
HOLD
TO
RESIST
TWISTING
LUBRICATE
O-RINGS
#6 LIQUID
HOSE
#10 SUCTION
HOSE
TIGHTEN
#6 HOSE
#10 HOSE
PRESS TAPE
O-RING/FITTING INSTRUCTIONS
O-RING,
SLIDE OVER
MALE INSERT TO
SWAGEED LIP
SUPPLIED OIL
FOR O-RINGS
Summary of Contents for 11301-VUY-A
Page 11: ......
