3
9)
Partition Mode
This setting will allow you to copy only the valid partitions of the source hard drive
(along with MBR/GPT table) bit by bit.
6.
Utilities
1)
Compare
This function will perform the data comparison process between the source and
target hard drive to ensure data accuracy.
2)
Verify Disk
This function will scan all
target
hard drives for readability.
3)
Measure Speed
This function will perform read and write testes to report the read speed for the
source hard drive and write speed of all target hard drives.
4)
Device Info
This function will show information regarding the hard drive connected to the
system.
5)
System Info
This function will show the system’s hardware & software information.
6)
Load Default
This function will reset all of the options back to the manufacture’s default settings.
Perform this function if the system is acting abnormal. Perform the “Shutdown”
operation and restart the system in order for these changes to take effect.
7)
Update Firmware
This function will update the software for the system. The update file needs to be
transferred to a Hard Drive pre-formatted as “FAT32” file system on a PC.
There are two options for this function:
Format Update HDD: This function will prepare a hard drive to be eligible for
firmware-update by format such hard drive in the source port as FAT16/32 File
System.
Update: This function will perform firmware-update with the firmware-update
hard drive that contains the firmware update file.
General Firmware Update Procedure:
a.
Pre-format a SATA Hard Drive using “Format Update HDD” function.
b.
Copy the manufacture certified update file onto such pre-formatted hard
drive via a PC/Mac.
c.
Insert such hard drive into the Source Port of the system.
d.
Execute the “Update” function.
e.
Restart the system when asked to do so.
It is strongly suggested that an upgrade to the system’s firmware not be performed,
unless the system is getting unstable and instructed to do so by a technician.