Vinotemp WINE-MATE WM-1500SLIM, Installation, Use & Care Manual

Page: 6 / 23

- 5 -
Installation Instructions
NOTES:
 DO NOT USE A GROUND FAULT INTERRUPTER (GFI).
 A DEDICATED 20 AMP CIRCUIT IS REQUIRED.
 DO NOT PLUG IN UNTIL 24 HOURS AFTER DELIVERY.
 Mounting brackets, screws, gaskets and other seal materials are not included.
 Do not install any ducts onto the supply, return, intake and exhaust.
 Because of potential safety hazards under a certain condition, we strongly
recommend against the use of an extension cord. However, if you still elect to
use an extension cord, it is absolutely necessary that it will be a UL LISTED
3-wire grounding type appliance extension cord having a 3-blade grounding
plug and a 3-slot receptacle that will plug into the appliance. The marked
rating of the extension cord shall be 115 V, 15 A.
1. Cabinet Location
 Place the wine cabinet in a properly ventilated location. Otherwise, heat
exhausted by the cooling unit will build up and it will not operate properly.
 The exhaust area must not be closed space and must be ventilated. The
ambient temperatures shall not be higher than 78°F for a WM-1500SLIM or
WM-1500SLIM-TE unit.
1) Rear Exhaust Cabinet Location
 Leave min 6 “clearance from the rear to the wall.
 Leave min 12” clearance from the top to the ceiling.
 Leave min 6” clearance from the left and right sides.
2) Front Exhaust Cabinet Location
 Leave min 6” clearance from the front if left and right sides unobstructed.
 Or, leave min 36” clearance from the front if left and right sides obstructed
3) Top Exhaust Cabinet Location
 Leave min 12” from the top to the ceiling.
 Leave min 2 “clearance from the rear to the wall.
 Leave min 2” clearance from the left and right sides.
4) Side Exhaust Cabinet Location
 Leave min 6 “clearance from the left or right side to the wall.
 Leave min 12” clearance from the top to the ceiling.
2. Cooling Unit Installation