Vinotemp WINE-MATE WM-1500SLIM, Installation, Use & Care Manual

Page: 14 / 23

- 13 -
6. Parameter Programming
1) Press and hold the SET + keys until the “ °C” or “°F” LED starts flashing,
then release the keys.
2) Press and hold again the SET + keys until the Pr2 label is displayed, then
release the keys. The first parameter Hy will be displayed.
3) Press up/down keys / to scroll to the required parameter within 10 sec.
4) Press the “ SET ” key to display its value.
5) Use up/down keys to change its value within 10 sec.
6) Press “ SET ” to store the new value and the display will flash 3 times.
7) To exit : Press SET + or wait 15sec without pressing a key.
PARAMETER DESCRIPTION DEFAULT VALUE
Set
set-point (
°
)
55
Hy
temperature regulation differential (
°
)
4
AC anti-short cycle delay (min) 10
Con compress on with probe faulty (min) 20
CoF compress off with probe faulty (min) 20
CF
temperature unit (
° F / ° C
)
F: Fahrenheit
rES display resolution in: integer
dLy temperature display delay (min) 1
ot
probe calibration (
°
)
0
LS minimum set-point (
°
) 50
US
maximum set-point (
°
)
65
idF defrost cycle interval time (hour) 12
MdF defrost cycle endurance time (min) 30
ALC temperature alarm type rE: relative to set-point
ALU high temperature alarm (
°
) 10
ALL
low temperature alarm (
°
)
10
AFH
alarm recovery differential (
°
)
5
ALd temperature alarm delay (min) 60
dAo temperature alarm delay on startup (hr) 23
SAA
heater set-point (
°
)
40
SHy heater regulation differential (
°
) 4
FSU fan action Std
FnC fan operating mode C-n: on with compressor & off during defrost
Fon fan on with compressor off (min) 0
FoF fan off with compressor off (min) 15
NOTE : Depending on the controller, not all parameters are used.
7. How to calibrate the air probe
If the actual cellar temperature differs from the setting temperature, set
parameter ot = actual cellar temperature minus set-point.
8. How to adjust defrost cycle