background image

VINO1500-2500SSW 

Installer’s Instruction 

 

Federal law requires that WINE-MATE split cooling systems be 

installed by an EPA certified refrigeration technician. 

 
WINE-MATE split system is shipped as components and is ready for use only 
after a certified refrigeration technician has properly installed, evacuated, 
charged and tested the system. Proper installation is critical. Vinotemp can only 
warrant the quality of the components. The installation and proper operation of 
the system must be warranted by the installer. Installation of the system must be 
done in accordance with all state and local building and electrical codes.  
The condensing unit and evaporator unit are connected by a liquid line and an 
insulated suction line that are supplied by the installer. These lines must be 
properly sized for the distance between the two units. After the units and the lines 
are installed, the system must be pressure tested. If no leaks are found, 
evacuate and charge system. Refrigerant amount will vary depending on the 
length of line set. 
 

1. Condensing Unit 
 

 Place the condensing units WM150SCU and 

250SCU in a properly ventilated location. If it is not, 
heat exhausted by the condensing unit will build up 
and the cooling system will not operate properly.  

  Condensing unit shall be elevated to avoid possible 

flooding and shaded from direct sun. It shall not be 
exposed to temperatures higher than 110 

°

F or lower than 50 

°

F (optional 

low ambient kit available). 

   Leave minimum 5 feet clearance for the exhaust side and leave minimum 

1 foot clearance for the fresh air intake side. 

 
 
 

Summary of Contents for WINE-MATE 250SCU








Reviews: