7
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
CORD INSTRUCTIONS
For your protection, this unit should be properly
grounded. Unit is equipped with a 3-conductor
cord set that has a molded 3-prong grounding-
type plug, and should be used in combination
with a properly connected grounding-type outlet
as shown in figure A.
It is not recommended to use this wine cellar
with an extension cord or power board. Please ensure that the appliance
is plugged directly into the electrical outlet. Avoid the use of three plug
adapters and do not alter the plug under any circumstance.
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
•
Remove the exterior and interior packaging.
•
Check to be sure you have all necessary parts and an owner’s
manual.
•
Before connecting the appliance to the power source, let it stand
upright for approximately 24 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth
and leave doors open to air out the unit BEFORE plugging in your
appliance.
Installation of Your Appliance
•
This appliance is designed to be free standing only, and should not
be recessed or built-in.
•
Do not install this unit in any area that is not properly insulated or
heated (such as a garage).
•
Leave at least 8" space from back wall.
•
Leave at least 6" space for each side.
•
Place your appliance on a floor that is strong enough to support it
when it is fully loaded.
•
Floor should be level.
•
Locate the appliance away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the coating
and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also prohibit the unit from performing
properly.
