INSTALLATION
§
Remove all packing material before using your wine cooler.
§
IMPORTANT
: Before connecting the unit to a power source, let it stand upright for approximately 24 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
§
Clean the interior surface with lukewarm water and a soft cloth.
§
This unit is designed for freestanding and built in installation and indoor use only. Position the unit in a dry
and well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 60°F
.
§
For built-in installation, leave a 1/4” (6.35mm) space on each side and at the top of the wine cooler
to ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct the front
exhaust vent with any objects as this may affect the unit from performing properly.
§
For freestanding installation, leave 6” of space at the back, 10-12” of space on each side, and unlimited
clearance at the top of the beverage cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this will
not allow for proper air circulation.
§
Do not slide the unit into place.
§
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level the wine
cooler, adjust the front leveling legs at the bottom of the wine cooler.
§
For best performance it is recommended that you install the appliance in a location with an ambient
temperature between 72-78°F
.
If the ambient temperature is above or below recommended temperatures,
the performance of the unit may be affected.
min 23 1/2”
15 1/4”
33 3/8”
Add 1/4” on each side and at the top.
Add 1” in the back of the cooler.
14 3/4”
22 1/2”
33 1/8”
8
