INSTALLATION
Remove all packing material before using your wine cooler.
Check to be sure you have all of the parts and an owner’s manual.
IMPORTANT
: Before connecting the unit to a power source, let it stand upright for approximately
24 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water and a soft cloth.
Place the wine cooler on a flat, dry surface that is strong enough to support it when it is fully
loaded. Use the adjustable (iron case) to place the cellar fully horizontal.
To level the wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
This unit is designed for freestanding installation only.
This unit is not designed for installation in a garage, basement, or any other location where a
controlled ambient environment between 50°F and 90°F cannot be maintained.
Avoid placing the wine cooler near any source of heat or moisture, or in direct sunlight. Extreme
hot and cold ambient temperatures may cause the unit not to perform properly or increased
electrical consumption.
Do not place the unit next to a major appliance that emits large a mount of heat, such as
dishwasher, microwave, oven, etc.
Do not plug unit into the same outlet as a refrigerator or microwave.
For freestanding installation, leave a minimum of 10-12 inches (25.4-30.4 cm) clearance on each
side, 6 inches (15.2 cm) clearance at the back side, and unlimited clearance at the top of the wine
cooler are suggested to ensure proper air circulation to cool the compressor and condenser.
This unit is not designed to be installed under a counter, inside a cabinet, or in any location t hat
does not allow the proper clearances on all sides.
Do not place heavy articles on the top of the cellar.
Do not slide the unit into place.
Avoid locating the unit in moist areas.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
9
Summary of Contents for Element EL-12TEDCS
Page 3: ...2...
