
9
732 South Racetrack Road, Henderson, Nevada 89015 U.S.A.
1.800.777.8466 | [email protected] | www.vinotemp.com
INSTALLATION
• Remove all packing materials before using your refrigerator.
•
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation. This unit is designed for freestanding or built in installation and for indoor use only.
Position the unit in a dry and well-ventilated place. Avoid placing the fridge near any source of heat or
moisture, or in direct sunlight. Do NOT install the unit in a location with an ambient temperature that will
fall below 41°F.
• For built-in installation, leave 1/4” (6.35mm) space on each side and at the top of the refrigerator to
ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct
the front exhaust vent with any objects as this may affect the unit from performing properly.
• For freestanding installation, leave 6” of space at the back, 10-12” of space on each side, and unlimited
clearance at the top of the fridge/cooler as suggested to ensure proper air circulation to cool the com
-pressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this will
not allow for proper air circulation.
• Do not slide the unit into place.
• Place the refrigerator on a level surface strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs at the bottom of the refrigerator.
• For best performance it is recommended that you install the appliance in a location with an ambient
temperature between 41-100°F. If the ambient temperature is above or below recommended tempera
-tures, the performance of the unit may be affected.
• Plug the fridge/cooler into an exclusive, properly installed-grounded wall outlet.
This diagram is for reference only.