A B
! Make sure to glue
securely, If not properly
glued, a failure in flight may
occur.
1-Trial fit each part before gluing . Be certain
that there are no gaps. If the parts will join,
but with a gaps, sand or trim the parts a little
at a time until the parts meet exactly with no
gaps.
2-Check for the correct dihedral angle
Carefully slide the wing halves together, ensuring that they are accurately aligned, Firmly press the two
halves together, allowing the excess epoxy run out. Clean off the excess epoxy
3-When joining the wing halves it is extremely important to use plenty of epoxy (30 minutes epoxy).
WING TOP-VIEW
1- Joining the wing
A B
IMPORTANT:
Please do not clean off the excess epoxy on the wing with strong solvent or pure alcohol, only use
kerosene to keep the colour of your model not fade.
2- Aileron servo installation
Extension cord
Cut away the covering of the wing bottom where the
aileron servo goes.
Install the servo extension cord in to the wing.
Install the aileron servo on the servo mount.
Aileron linkage
AILERON SERVO
WING BOTTOM-VIEW
WING BOTTOM-VIEW
Attach the control horn on the aileron with 2x15mm screws.
Screw the clevies halfway on the theared end of the aileron
push rod. Attach the push rod to the aileron horn. Mark the
position where the push rod will attach to the servo arm.
Cut off the excess length of the push rod
Plastic control horn
..........2
...................4
..........2
Included with the
radio set.
X
X
3mm set Screw
2 mm
Aileron pushrod
D=5/64”(2mm)
Ensure that the servo is centered. If necessary, adjust the
metal clevis so the aileron is also in the neutral position.
20mm
15mm
Cut the hole for the
aileron servo extension.
