●
Click
Save
followed by
Apply
- When you click
Apply
, the Pulse Server will download the
directory settings to all the IP intercom stations and do a
system reboot.
L
Password
is an optional field you can set to increase the
security level. The password is used by other intercom stations
to register with the Pulse Server.
2.5 Verify System Setup
To verify that your system is up and running:
Select
Server Management
>
Server Monitoring
All stations that have been configured should be displayed in
the table. Stations that are up and running will have the status
Registered
.
2.6
Configure Call and Audio Settings
It is optional to configure the call and audio settings. Default
settings will be used if they are not configured.
●
Select
Server Management
>
Server Configuration
>
Call and Audio Settings
The
Call and Audio Settings
menu include the following
parameters:
Autoanswer
Auto-answer is typically enabled for substations and not for
master stations.
Disconnect By Button
When disabled, the user cannot disconnect the call from this
station. It is typically disabled on substations and enabled on
master stations.
Activate Relay On Event
Most IP stations have a relay. Here, you can select the events
that activate the relay. The available events are:
- DTMF <#> - Reception of a DTMF (keypad) digit from a
remote station during the call
- Ringing
- In call
Relay duration
When the relay is activated, this parameter determines how
long the relay should stay ON.
Speaker Volume
This parameter sets the speaker volume for the station.
Noise Reduction
This parameter enables active noise cancellation. For stations
that are located in noisy environments, it is recommended
that the noise cancellation level be set to 4.
2.7
Configure the Call Buttons on an IP Substation
The IP Substation has three inputs. By default input 1 (Key
1) is connected to the call button, while the other two inputs
(Key 2 and Key 3) are free and can be used for additional call
buttons.
The call buttons of the IP Substations can be configured via
the Pulse Server.
●
Use a web browser and log into the Pulse Server station
(e.g. 169.254.1.99)
●
Select
Server Management
>
Server Configuration
>
Direct Access Key Settings
●
Select the station on which you want to program the Call
Button
- The Call Button is
Input Button 1
●
Under
Value
enter the directory number to call when the
button is pressed.
If you want to use also input 2 (Key 2) and input 3 (Key 3),
simply enter the required value for
Input Button 2
and
Input
Button 3
.
2.8 Add SIP Accounts for 3
rd
-party IP Telephone
and IP DECT
Install license
Before adding SIP accounts to your system, you need to
obtain the
Pulse 3rd Party SIP Terminals
license key.
●
Under the
Station Administration
tab, select
Licensing
●
Enter the license key in the
New License
field and click
Insert License
The
Licensing
table should now show all the licenses that
are available.
2.8.1 Create SIP station account
●
Under the
Server Management
tab, select
Server
Configuration
>
Directory Settings
●
Under
Third Party SIP Terminals
enter the
Directory
Number
,
Name
, and
Profile
for the IP telephone.