Vincent
37
Operation
Button(s)
Description
Switch on and off
POWER (1)
The device is switched on and off at the front side. If the switch is in the off
position, the device is disconnected from the mains. The device does not
possess any function of the operating state (standby). In switched on-mode
the lights shines on the power switch LED. Before turning on as a precauti-
on the volume of the precursor (7) (17) should be reduced.
Select an input
INPUT (9)
TAPE (8)
The input selection can only be made on the front panel. The knob
"INPUT" has four notches for the four input sources at the ports "TUNER",
"DVD", "AUX" and "CD". By turning the knob, the desired source can be
selected.
Before switching over the input channel, the volume (7)(17) should be tur-
ned down as a precaution!
Change the volume
VOLUME (7)
VOL
/
(17)
On device: Turn the knob "VOLUME" clockwise to increase the volume and
counter clockwise to decrease the volume.
On the remote: Hold the button "VOL
" button to adjust the volume to
increase. Use "VOL
" to reduce it. While the volume is adjusted, the LED
attached in the volume button shines.
The volume control affects the signal of the speaker and the output "PRE
OUT" (12). The output signal of "REC OUT" (11) remains unaffected.
Mute the speakers and
the preamplifier output
MUTE (16)
The mute button only works with the remote control key. It turns off the loud-
speaker and the signal from the preamp "PRE OUT" (12). While the device is
muted, the LED flashes on the power switch. Pressing again will restore the
volume. The output signal of "REC OUT" (11) remains unaffected.
Change height
proportions of the
sound
TREBLE (3)
With the knob "TREBLE" at the front, you affect the proportion of the higher
tones of the sound image. Clockwise rotation increases the intensity set,
moving counter clockwise reduces the intensity. The setting is only effective
if the "TONE" button (6) is pressed. The tone control affects the signal of
the speaker and the output "PRE OUT" (12). The output signal of "REC
OUT" (11) remains unaffected.
Change the bass
proportions of the
sound
BASS (4)
With the knob "BASS" on the front, affect the proportion of the deeper
tones of the sound image. Clockwise rotation increases the intensity set,
moving counter clockwise reduces the intensity. The setting is only effective
if the "TONE" button (6) is pressed. The tone control affects the signal of
the speaker and the output "PRE OUT" (12). The output signal of "OUT
REC" (11) remains unaffected.
OPERATING THE APPLIANCE
