Vincent
35
If each loudspeaker is connected completely normally with a twisted loudspeaker cable, then (usually with
the supplied loudspeakers) the contact bridges (usually small metal panels or short cable bits) must be atta-
ched in each case between the two clamps of same polarity (e.g. both with "+ “ marked clamps) with
loudspeakers with double connection (four loudspeaker clamps). With "+" and "R" marked connector of
the amplifier is connected with one of the "+" marked bridged connections of the right speaker.
Connected with "-" and "R" marked connector of the amplifier is with one of the "-" selected, bridged con-
nections of the right speaker. For the speaker cable between the ports of the left speaker is the appropria-
te allocation to be chosen.
CONNECTION OF THE LOUDSPEAKERS
If you are using ready made loudspeaker cables
with 4 mm banana plugs, all you need to do is
connect the two plugs on each loudspeaker cable
end to the two associated speaker connectors. Turn
the connector screws clockwise to fasten them.
If you want to use speaker cables equipped with
spade lug connectors, every connector screw must be
opened by turning counter clockwise. After that, the
lug must be moved under the screw head. Then, turn
the screw clockwise to fasten the lug to the connector.
To avoid damages to the amplifier, make sure the con-
nection is tight and no bare metal from the cable lug
connector makes contact with the rear panel or with
another terminal.
If no connector is to be used, remove approxima-
tely 1 cm length of insulation from each end of the
speaker wire. Twist the braid in order to avoid
short circuits. Turn the fastener on the loudspeaker
terminal counter clockwise to loosen it and introdu-
ce the bare wire end into the exposed connector
hole. Then turn the fastener clockwise so that the
wire is firmly clamped. Make sure the connection
is pretty tight.
