VMM-T1 User Manual
11
* THIS IS A DISCONTINUED PRODUCT*
2.
Remove the label before proceeding.
3.
Check the line fuses to be sure they are the proper rating. For 230 VAC operation, change the
two line fuses to two 3AG, 0.25A time-lag (supplied). See “
Line Fuse Replacement
”
instructions elsewhere in this manual.
4.
Be sure the AC module power switch is toggled to the “0” position and the line cord is NOT
connected to the AC line.
5.
Connect the supplied line cord to the rear panel AC module receptacle. Be sure the cord is
inserted completely into the AC module receptacle.
6.
Connect the line cord to the AC line.
7.
Please Note: The VMM-T1 power switch is located on the rear of the case. Please be sure that it
is readily accessible at all times when in use.
8.
Power ON the unit by toggling the AC module power switch to the “1” position. Power LED
indicator will illuminate.
Line Fuse Replacement
1.
A small flat-bladed screwdriver or similar tool is needed to complete this procedure. Please refer
to Figure 1.
2.
BE SURE THE LINE CORD IS DISCONNECTED FROM THE LINE VOLTAGE
POWER SOURCE. DO NOT
CONTINUE WITH THIS PROCEDURE WITHOUT
REMOVING THE LINE CORD FROM THE VMM-T1
.
3.
Unplug the line cord from the AC module receptacle of the
VMM-T1.
4.
Position the
VMM-T1
unit so that the rear panel is facing.
5.
Please refer to Figure 1. Using the small flat-bladed screwdriver or similar tool, insert the tool
into the cover door slot, gently pry open cover door.
6.
Insert the tool into the fuse holder slot and gently pry out the fuse holder block.
7.
Remove defective fuse(s); replace with new fuse(s).
8.
Replace fuse holder into housing.
9.
Close the cover door.
To avoid injury or death, unplug the line cord from the line
voltage power source before continuing.
WARNING
