Page 2
shading solutions by
VIMCO
TM
Replace Idler Pin
A.
Place the adjustable hub onto the end of the coupled
idler pin.
B.
Tighten the two (2) hex screws on the adjustable hub
snug enough to keep the shade from unrolling.
I. Pre-Installation
II. Fasten Mounting Brackets
Attach Adjustable Hub
Fasten Mounting Brackets
A.
Mark a vertical center line with respect to the fabric gap / windows.
B.
Mark 3/4” (19 mm) from the center line of the fabric gap / windows toward the MDU. This designates where the
fabric locators of the idler mounting bracket will be positioned.
Note:
This bracket placement is based on a right-mounted MDU. The bracket placement for the left-mounted
configuration will be reversed.
Note:
These screws will be loosened again
near the end of installation for final
adjustments.
A.
Remove the idler pin from the shade coupler (from
the shade to be mounted closest to the MDU) by first
removing the retaining screw using a #2 phillips
screwdriver.
B.
Place the new coupled idler pin in the shade coupler
and replace the retaining screw.
Center Line of the Fabric Gap / Windows
1 1/2" (38 mm) Fabric Gap
Idler Bracket
Fabric Locators
Right-mounted
MDU
Idler Pin
Coupled Idler Pin
1st Shade
1st Shade
Retaining Screw
3/4" (19 mm)
1
1
2
