3
The
ZBA6 is a kit consisting of: a NIMH 24 V battery with a capacity of 2200 mAh
and a battery charger capable of charging lead-acid and NiMH 24 V
batteries, all contained in a dedicated plastic box. The ZBA6 can be installed on the following equipment: RS05, RS06, RS07 and RS08
The battery charger is equipped with voltage and current charging control, temperature control for NiMH batteries, battery disconnection and mains failure
control with automatic switching.
Battery charging is also regulated by a timer, which prevents overcharging by setting it on trickle charging.
By pressing
button P1
you can stop charging, restart or reset the voltage when a battery is inserted with the board switched off.
If charging occurs during a power failure, charging will resume automatically when power returns.
Power failure is monitored directly by the input voltage or by an optional additional opto-isolated input.
In the event of a power failure with the battery voltage too low, to prevent damaging the battery, it will be disconnected and the battery charger will switch off:
When power returns the battery charger will switch on and start charging the battery.
The battery charger is protected by a
15 AF
fuse F1 against overcurrent or short-circuiting, and a
500 mAF fuse F2
against any reversal of polarity or charging
over-current.
GB
OFF
ON STEADY
BLINKING
GREEN
End of charging and/or
Trickle charging
Battery supplying power to the board
RED
Battery charging
GREEN + RED
Battery charger off:
battery voltage too low
battery just connected
Error:
battery damaged
battery disconnected
fuse blown
LED status
24V NiMH Battery
Capacity (type)
Charging current
Maximum charge duration
Trickle current
Time required to complete charging
2200 mAH (AA)
250 mA
10 hours at 250 mA
90 mA
10+9=19 hours
Note:
The table gives the maximum time for charging a completely discharged battery.
NI-MH 24 Vdc Batteries
