13
10. Operations on remote controls
10.1 Saving:
a. Set the
DIP-switch 3
to
ON
and the display will show
i
(Install Remote Controls).
b. Press the
SELECT
button to scroll through the free addresses for remote control acquisition.
c. Run the procedure for installing the remote control (refer to its installer sheet).
d. If saving is successful, the display will show the next free address for a new acquisition.
e. At the end, set
DIP-switch 3
back to
OFF
.
Caution:
If the display shows
E
, it means there has been an error when saving; in which case, press the
SELECT
button and run the procedure again.
10.2 Acquisition of the Remote Control
The general procedure for acquiring the Remote Control is illustrated below (for all the various configura-
tions, refer to the relevant instruction sheet).
- Prepare the radio interface for acquiring the device (as per points a. and b. of subsection 9.1).
- Insert the battery in the remote control, if not already inserted.
- Press remote control buttons
and
together.
- The LEDs inside the remote control will emit a short flash for a moment and will light up steady on the
response of the radio interface.
- Then continue from point d.
10.3 Selective deletion
a. Set the
DIP-switch 2
to
ON
; the display will show
C
(Delete Remote Controls).
b. Press the
SELECT
button and the display will show
u
(All).
c. Press the
SELECT
button to scroll through the devices installed in the system.
d. Press the
PROG
button you have decided which device to delete, the display will show
C a
(Delete).
e. Press the
PROG
button to confirm deletion and the display will show
- -
.
f. Press the
SELECT
button to continue scrolling through the devices installed in the system.
g. At the end, set
DIP-switch 2
back to
OFF
.
By-alarm
Operations on remote controls
